Bmr-suspension UTCA034 Manual do Utilizador descarregar pdf

UPPER CONTROL ARM AND MOUNT

UTCA030, UTCA031, UTCA032, UTCA033, UTCA034, UCM002 – 2011-PRESENT FORD MUSTANG

Tools required:

o 3/8”, ½” drive ratchet or impact wrench

o Sockets – 18mm, 21mm deep, 24mm,

25mm, 27mm

o Hydraulic jack and stands or service lift

o Pry-bar

Installation:

1. Remove the lower rear seat cushion to gain access to

the upper control arm mounting bolt. Located

directly above the drivers and passengers side

footwells there is a push release that detaches the

seat cushion. Once each release is popped, the

lower seat cushion can be removed.

2. Using a 24mm socket, remove the large bolt on the

driveshaft tunnel. (IMAGE 1)

3. Lift the vehicle until there is sufficient work space

under the car. Support with jack stands.

4. Using a 21mm deep socket, remove the upper

control arm bolt at the axle. (IMAGE 2)

5. Knock the bolt out, separating the control arm from

the axle. NOTE: it may be necessary to support the

front of the axle to remove tension from the control

arm bolt.

6. Using an 18mm socket and long extension, remove

the (2) remaining upper control arm mount bolts and

remove the upper control arm mount and control

arm out as an assembly. (IMAGE 3)

1 2 3

UPPER CONTROL ARM AND MOUNT UTCA030, UTCA031, UTCA032, UTCA033, UTCA034, UCM002 – 2011-PRESENT FORD MUSTANG Tools required: o 3/8”, ½” drive ratchet

2 UPPER CONTROL ARM AND MOUNT (CONT.) 7. Using a 25mm wrench or socket for the bolt head and a 27mm socket for the nut, remove the front control

3 UPPER CONTROL ARM AND MOUNT (CONT.) ADJUSTING PINION ANGLE WITH AN ADJUSTABLE UPPER CONTROL ARM Make sure the rear end is loaded by either sett

Sem comentários

Bmr-suspension UTCA034 Manual do Utilizador